Home > NEWS & EVENTS

Analysis of maintenance of rotary kiln

Rotary kiln has a very high utilization value in the field of building materials. Its main function is to calcine various materials. Usually, the materials include limestone, calcium carbonate, lime, carbon, ceramsite sand, etc., and it is necessary to effectively extend the equipment. The service life of the equipment must be properly maintained and maintained. This article focuses on equipment maintenance and maintenance knowledge:
1. before use
Before the official start-up, it is necessary to check in detail whether the equipment meets the start-up standards, including whether the ambient temperature matches the operating temperature of the equipment. If the requirements are not met, the temperature sensor should be used for manual adjustment; secondly, see if the amount of the motor oil is specified. Within the scope, it is necessary to properly add lubricating oil, pay attention to the specifications and dosage of the lubricating oil, too high or too low are not conducive to normal production, and to a certain extent will also cause waste, which is the work that must be checked before use.
2, in use
After the preparatory work is ready, the equipment must be turned on. During the normal use, the user must check the working status and operation of the equipment. The user must carefully identify various noises. Usually, different noises are generated. It means that the fault point is different. Under normal circumstances, the motor has encountered various problems. The user must always sum up experience and must be aware of the seriousness of the problem so as to ensure that the device is better used by the user.
3, after use
In the process of equipment maintenance and maintenance, this is a key step. Once the equipment is shut down, it must be cleaned and cleaned in a comprehensive manner. Pay attention to whether there are foreign matter or foreign matter in the feeding inlet and discharge port of the equipment. Otherwise it will affect the purity of the material, if serious, it will cause the equipment cylinder or crash, and if the equipment in the normal operation of the phenomenon of crashes, timely reset the reset switch in order to ensure that the equipment is normal The use of boot.

If you are interested in our products, Please get in contact with us .

MESSAGE

RELATED PRODUCTS

  • Selection of Raw materials and Fuels for Lime Production Proc

    Selection of Raw materials and Fuels for Lime Production Proc

  • What are the main uses of calcined lime by lime kiln?

    What are the main uses of calcined lime by lime kiln?

  • Active Lime Kiln Production Process

    Active Lime Kiln Production Process

  • Magnesite Calcination Rotary kiln to Produce Light Burning Ma

    Magnesite Calcination Rotary kiln to Produce Light Burning Ma

Wechat:+86 18937185591

Please press to copy the number,then pasete it to chat

Get Quote